Cabinet and cabinet fittings installation process

Installation cabinet once: preparation: before installation, the installation site crossed to accurate, otherwise the late lead to rework. According to the split open a case to guide unpack boxes and cabinets in wooden cases. Cabinet in place: put the cabinet in planning a good position, ensure the alignment around before and after positioning the location of the cabinet. Cabinet level adjustment: the top vertical cabinet put ruler, guarantee his parallelism, moves cabinet on foot with a wrench screw adjusting his height, reagent cabinet level, then lock the nut of the cabinet anchor.
cabinet fittings installation process: cabinet fittings installed including the famous cabinet, cabinet and cabinet door installation of ground wire. Installation cabinet doors, cabinets QianHouMen all the same, is composed of the left door and throttle double open the door. The role of the cabinet door: can make the equipment within the cabinet of the electromagnetic shielding layer, protect the cabinet equipment by electromagnetic interference, and can avoid the equipment with the outside world to prevent equipment damage. ( 1) Shaft pin at the bottom of the door and around the box under the cabinet pin hole of shaft alignment, the bottom of the door. ( 2) With the hand to pull the door at the top of the shaft pin, the shaft pin hole is aligned with the shaft pin hole cabinet on the lintel. ( 3) Loosen the hand, under the action of a spring shaft to reset, make the door of the upper shaft pin inserted into the cabinet on the lintel corresponding hole, which installed on the cabinet door. ( 4) According to the above steps, to complete the installation of the other cabinet door.
information: network cabinets chassis cabinets design basic requirements